Applying Power To The Charger; Introduction To Presets - Hobby King Turnigy 10XC User Manual

3. When charging two packs simultaneously, connect the discharge wires into the banana jacks as shown
below.

Applying power to the charger

To apply power to the charger: Connect the charger to a 10V to 32V DC power supply, field battery
or car battery. If your bench power supply is equipped with banana jacks for output, you can remove
the plier clips from the charger's input cables and plug the cables directly into the power supply jacks.
When the charger is powered up, it displays the following "Welcome" screen:
Press the MODE button one time to advance to the "Preset Menu"
Preset 1
[chem] [BAL] @ [charge current]*
Press the MODE button repeatedly to scroll through and view/select the Turnigy 10XC's 10 presets,
one at a time.
*Information in square brackets varies.

Introduction to presets

As shipped from the factory, the charger has ten presets. The presets are displayed in the "Preset Menu"
and display in the charger's LCD as follows:
Preset Name/Settings
Preset 1
LiPo BAL @ 1.0A
P2 Dual Channels
LiPo BAL @ 1.0C
Preset 3
LiPo BAL @ STORE
Preset 4
LiPo 2sU @ 1.0A
Preset 5
A123 BAL @ 4.6A
P6 Dual Channels
A123 BAL @ 4.6A
Preset 7
A123 2sU @ 4.6A
January 17, 2012 ver 1.0 www.revolectrix.com
Turnigy 10s
[firmware version]*
Description
Designed for a single 1s-10s LiPo battery, balance
charged at 1.0 Amps.
Designed for two, 1s-5s LiPo batteries, balance
charged at 1.0 Amps.
Designed to automatically storage charge or discharge
LiPo batteries to 3.8v per cell for safe storage.
Preset will charge or discharge using 1A internal
balance circuits.
Designed for one 2s LiPo, unbalance charged at 1.0A.
Designed for 1s-10s A123 battery, balance charged at
4.6A.
Designed for two, 1s-5s A123 batteries, balance
charged at 4.6A.
Designed for one 2s A123, unbalance charged at 4.6A.
10