Table of Contents
Advertisement
*Cells are numbered from 1 through n, where 1 is the first cell in the pack connected to Ch1, and n is the last cell in the pack
(if only one pack is being charged) or the last cell in the pack connected to Ch2 (if two packs are being charged).
†For the charger to calculate internal resistances, pack must be at less than 80% fuel level at start. Internal resistances will
be available for display after about 12 minutes of charging, and will be periodically updated after that.
5. Note, when you press and hold the START/STOP button to initiate a charge or storage operation
(step 2 above), you are actually starting a charge "session". During a session, the data is logged to the
charger's memory, the displayed on the charger's LCD. When the charger is allowed to finish the
operation, the LCD will read, e.g.,
To end the charge session and clear logged data: Press the START/STOP button for one second.
The charger flashes
Note: Pack data is lost when you end the charge session, so if you want to see it, cycle through the saved
data by pressing the MODE button before pressing and holding the START/STOP button.
To cancel charging at any time: Press and hold the START/STOP button for one second. The
CHARGER STOPPED
charger flashes
Note: Pack data is lost when you end the charge session, so if you want to see it, cycle through the saved
data by pressing the MODE button before pressing and holding the START/STOP button.
Options Menu Explained
In addition to the charger's Preset Menu, and Main Menu, there is also an Options Menu available for
altering basic charger settings using the charger's interface. The Options Menu is accessed by pressing
and holding the MODE button while you power up the charger.
1. Press and hold the MODE button while you power up the Turnigy 10XC.
2. Continue holding the MODE button; the charger will enter the Options Menu and immediately start
to cycle through the following menu items;
CONNECTOR
QUIET CHARGING
,
setting you want to change or press and hold the MODE button again to begin cycling through the
Options Menu items again. If you accidentally release the MODE button when the LCD reads
begin again at step 1 above.
3. At this point, there are several things you can do:
January 17, 2012 ver 1.0 www.revolectrix.com
Ch1
42mAh In
Ch2
40mAh In
1:3.956V 2:3.956V
3:3.956V 4:3.956V
screen auto scrolls to show all cells:
5=3.966V 6=3.966V
7=3.966V 8=3.966V
1:12.3mΩ
2:13.2
3:12.1mΩ
4:14.2
screen auto scrolls to show all cells:
5=11.8mΩ
6=13.5
7=12.4mΩ
8=12.6
LiPo [BAL] DONE
CHARGER STOPPED
then displays the Preset Menu.
then displays the Preset Menu.
CHOOSE SPLY AMPS
Exit
,
. Release the MODE button only when the LCD reads the
mAh put back into pack(s) during charging.
Individual cell voltages.* ":" indicates Ch1
Individual cell voltages.* "=" indicates Ch2
Individual cell internal resistances in
milliohms.*† ":" indicates Ch1
Individual cell internal resistances in
milliohms.*† "=" indicates Ch2
LOW SUPPLY VOLTS
,
15
NODE
,
Exit
,
Advertisement
Table of Contents
