Using The Automatic Needle Threader; Using The Spool Net - Brother 884-T78 Operation Manual

Using the Automatic Needle Threader

Automatic
Needle
Threader
Rotate handwheel towards you until
1
needle is in the highest position,
and lower presser foot.
Take thread in your left hand, and
2
gently pull it forward.
Before sewing, pull the thread loop to the
6
right and then pull the thread tail towards
the back of the machine following the
opening in the presser foot.
16
Thread
Pin
Lower automatic needle threader.
3
Pull thread along the right side of the pin.
✽
Do not force the needle threader lower
✽
than the eye of the needle. Be sure that
the needle is in the highest position.
Needle (HLX5) Thread
#9 #20 #30 #50 #60
#11 #20 #30
#14 #20 #30
#16 #20
The automatic needle threader cannot be
●
used with the thread-needle combinations
illustrated in the chart shown above.
Transparent nylon thread can be used
regardless of the chart, providing the
needle used is a #14 or #16.
1
Hook
Pull the thread to
✽
the left and check
2
that it is caught
on the hook.
Turn the needle threader lever all the
4
way in the direction of 1 and when
the hook extends from the needle
hole, pull the thread in the direction
of 2 to catch it on the hook.

Using the Spool Net

a
c
b
While holding the thread gently, return
5
the needle threader lever to the right. As
you do this the hook that has caught the
thread will move as well, pulling a loop
of thread through the eye of the needle.
If using transparent nylon
thread, metallic thread, or
other strong thread, place
d
the included spool net over
the spool before using.
If the spool net is too long,
fold it once to match it to the
spool size before placing it
over the spool.
Spool net
1
Thread spool
2
Spool pin
3
Spool cap
4