Memory - Medisana FTO 76073 Manual

GB

3 Memory

3.1 Recalling stored data
The MEDISANA FTO infra-red ear thermometer can store up to
12 results.
You can call up your stored data with a short press of the START
button , without having previously switched on the thermo-
meter with the ON/OFF button
the display next to "- - -". After a further short press of the
START button
display, followed directly by the last stored temperature reading.
The symbol M will flash below the unit of measurement.
With a further press of the START button
the result stored in memory slot "2". A total of 12 memory slots
are available, and these will be displayed in order if you continue
to press the START button
If a memory slot is empty, the symbol "- - -" will appear next to
it in the display.
3.2 Changing the unit of measurement
When taking temperature, you have the choice between degre-
es centigrade and degrees Fahrenheit.
Proceed as follows:
1. The unit must be switched off.
2. Hold down the START button
at least 10 – 15 seconds until the current unit of measure-
ment is shown in the display.
3. You can now change the unit of measurement with a further
short press of the START button
measurement is displayed, wait until all the display symbols
flash in the illuminated display and the change is confirmed
with a short tone. Directly after this, the thermometer is ready
to take the next reading with the newly selected unit of
measurement.
4. At the same time, all stored data is automatically converted
to the new unit of measurement..
14
, memory slot number 1 will appear in the unlit
.
. The symbol M will flash on
, you can call up
on the back of the unit for
. Once the desired unit of