Chapter1; Warnings And Safety Devices - Extraflame LP14 User Manual

Chapter1

WARNINGS AND SAFETY DEVICES

INTRODUCTION
The boilers produced by our establishment are built with attention to the individual components in a way
to protect both the user and the installer from any accidents. It is therefore recommended that after any
intervention on the product, that authorised staff pays particular attention to the electric connections,
especially the stripped parts of the wires. These must not escape from the terminal board in any situation,
thus preventing possible contact with the live parts of the wire.
The instruction manual is an integral part of the product: make sure that it always accompanies the
appliance, even if transferred to other owners or user or is transferred to another place. If it is damaged or
lost, request another copy from the area technician.
This boiler must be destined for the use for which it has been expressly realised. The manufacturer is
exempt from any liability, contractual and extracontractual, for injury/damage caused to persons/animals
and objects, due to installation, adjustment and maintenance errors and improper use.
INSTALLATION
Installation of the boiler and auxiliary equipment in relation to the heating system must comply with all
current Standards and Regulations and to those envisioned by the law. Installation must be carried out
by authorised staff , which must provide the buyer with a declaration of conformity for the system and
will assume full responsibility for fi nal installation and as a consequence the correct functioning of the
installed product.
It is necessary to bear in mind all laws and national, regional, provincial and town council Standards present
in the country the appliance has been installed.
Extrafl ame S.p.A. cannot be held responsible for the failure to comply with such precautions. Before
installation, wash the pipes of the system well in order to remove any residues that could compromise the
correct functioning of the appliance. During installation, inform the user regarding:
a. In case of water leaks, he must close the water supply and promptly warn the after-sales technical
service.
b. The system working pressure must be checked periodically. If the boiler is not used for a long period of
time, it is recommended that the after-sales technical service is contacted to carry out at least the following
operations:
- Position the master switch on position 0.
- Close the water taps of both the heat system and the domestic hot water system;
- Empty the heating system and the domestic hot water system if there is risk of freezing.
COMMISSIONING
After the packaging has been removed, check the integrity and completeness of the contents.
If this does not comply, contact the dealer where the appliance was purchased.
During commissioning of the product, check the correct functioning of all devices, both safety and control,
which make up the boiler. All electrical components that make up the boiler must be replaced with original
spare parts exclusively by an authorised after-sales centre, thus guaranteeing correct functioning.
Before leaving the system, the staff in charge of commissioning must check boiler functioning for at least
one complete work cycle. The boiler must be serviced at least once a year, programming it in advance with
the technical after-sales service.
7
WARNINGS AND SAFETY DEVICES