Dispensing Coffee; Programming The Quantity Of Coffee In A Cup; Saving Energy; Daily Maintenance - Caffitaly System S05 Instruction Book

• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently into place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the coffee dispensing spout (Fig. 7 or 8).
• Press and release button A or B, depending on the desired coffee.
• The pressed button will fl ash. The machine will stop dispensing on reaching the
programmed quantity and emit a beep.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
NOTE: the quantities of coffee dispensed can be programmed according to personal
taste and the size of the cups or espresso cups used.
To program the quantities, please refer to ch. "Programming the quantity of coffee in
a cup".

Programming the quantity of coffee in a cup

• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently into place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the dispensing spout (Fig. 7 or 8).
• Press and hold the desired coffee button.
• On reaching the desired amount of coffee, release the button. Now the button is
programmed. The quantity of coffee dispensed can be programmed from a minimum
of 20 up to a maximum of 250 ml.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
The machine will automatically reduce consumption one hour after it was last used.
Buttons A-B-C blink slowly and sequentially. To restore normal operating conditions,
press any button or raise the lever. The appliance will start warming up. When the
buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
During normal operations, warning light F may come on. The capsule expulsion
process should be carried out while the machine is switched on. If this is done
while the machine is switched off, the count of capsules deposited in the drawer
will not be reset. As a result, the warning light may come on even if the capsule
drawer is almost empty.
• Remove the drip tray and used capsule drawer (Fig. 6).
• Lift the used capsule drawer (Fig. 11); empty and rinse it.
• Remove the grid (Fig. 12). Empty the drip tray and rinse it out with water.
• Remove the water tank (Fig. 5); empty and rinse it.
Use a soft cloth and a neutral
detergent to clean the surfaces of the
appliance. Do not use jets of water to
clean the appliance.
English

Dispensing coffee

Saving energy

Daily maintenance

The plastic parts of the machine,
including the water tank, are NOT
dishwasher safe.
19