Remote 14 Receptacle Rc3 Information (Models With Cv Option); Terminal Strip 2T Connections (Models With Cv Option) - Miller Big Blue 400D Owner's Manual

4-9. Remote 14 Receptacle RC3 Information (Models With CV Option)

A J
K K
I I
B B
C L N
M M
D D G G
F
E
*The remaining sockets are not used.

4-10. Terminal Strip 2T Connections (Models With CV Option)

2
H
OR OR
Ref. ST-800 862-B Ref. ST-800 862-B
1
Socket*
A 24 volts ac. Protected by circuit
breaker CB4.
B Contact closure to A completes 24
volts ac contactor control circuit.
I 115 volts ac. Protected by circuit
breaker CB3.
J Contact closure to I completes 115
volts ac contactor control circuit.
G Circuit common for 24 and 115
volts ac circuits.
C 0 to +10 volts dc output to remote
control from min to max of Amper-
age/Voltage control R1.
A/V A/V A/V D Remote control circuit common.
E 0 to +10 volts dc input command
signal from remote control.
K Chassis common.
Y Stop engine.
If remote control plug does not fit in
receptacle RC3, wire cord directly
to terminal strip 2T.
Y Do not connect to Remote 14
receptacle RC3 and terminal
strip 2T at the same time. Use
only one remote control
method.
Open right side door.
1 Cover
2 Terminal Strip 2T
Connect leads to 2T using terminal
information shown in Section 4-9.
Reinstall cover. Close door.
Socket Information
Tools Needed:
Ref. ST-800 862-B / Ref. ST-185 316
OM-463 Page 19