Mount The Console To The Console Mast; If You Have The Q47E/Q47Ce Console - Octane Fitness Q47e Assembly Manual

6. mount the console to the console mast

Note: Record the serial number of your console, located on the lower edge of the console, before
attaching the console to the console mast. (If you have installed the optional LCD Mounting Arm,
and mounted the console to the mast according to those instructions, skip to Step 7.)

If you have the Q47e/Q47ce console:

a. Position the console (1) on the plate at the top of the mast
(B) and place the left back arc (3) behind it. Holding both
in place, insert 2 of the longer (18mm) Phillips screws
partially through the back arc (3) and the mast plate into the
console back. Repeat on the right side. Tighten all screws
to secure.
b. Attach the white 12-pin main connector to its connection on
the back of the console. Tug the cable gently to ensure
the connector is completely seated.
c. Attach the black keypad connector to its connection on the
back of the console. Tug the cable gently to ensure the
connector is completely seated.
d. Attach the metal connector on the green ground wire that
is connected to the back of the mast plate to its connection
on the back of the console. Tug the ground wire gently
to ensure the connector is completely seated.
e. Attach the white 3-pin heart rate connector to its connection
on the back of the console. Tug the cable gently to
ensure the connector is completely seated.
f. Attach the white 2-pin fan connector to its connection on
the back of the console. Tug the wires gently to ensure
the connector is completely seated.
g. Plug in the unit and verify that the console LEDs light and
that the Level and Stride control buttons on the moving
handlebars are working. If you have the Q47ce console,
grasp the contact heart rate handgrips and verify that a
heart rate reading appears on the console. If any issues are
detected, recheck the connections, or contact Octane Fitness
Customer Service for assistance. Once you have verified
these functions, unplug and proceed with remaining steps.
h. Make sure excess cable is pushed into the mast tube.
i. Reposition the console back piece and reattach it using the
two screws provided.
Console to Base
(white, 12-pin)
Console Ground
All models
(metal; green wire)
All models
Keypad
(black)
All models Q47e/Q47ce only
Heart Rate
(white, 3-pin)
Q47e/Q47ce only
Fan
(white, 2-pin)
11