Table of Contents
Advertisement
Mounting the Base Unit on a Wall
Standard Wall Plate Mounting
This phone can be mounted on any standard wall plate.
1
Make the AC adapter and the telephone line cord through the hole on the wall
mount adapter.
2
Plug the AC adapter into the DC IN 9V jack.
3
Plug the telephone line cord into the TEL LINE jack.
4
Slide the wall mount adapter into the notches on the base.
5
Plug the AC adapter into a standard 120V AC wall outlet. Hook the cord on the
notch of the wall mount adapter.
6
Plug the telephone line cord into the telephone outlet. Hook the cord on the notch
of the wall mount adapter.
7
Align the mounting slots on the base with the mounting posts on the wall. Then
push in and down until the telephone is firmly seated.
!
DO NOT use an AC outlet controlled by a wall switch.
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your phone directly to the wall. Before doing
this, consider the following:
•
Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting
screws into the wall.
•
Try to mount your telephone within 5 feet of a working phone jack to avoid excessive lengths.
•
Make sure the wall material is capable of supporting the weight of the base and handset.
•
Use #10 screws (minimum length of 1 & 3/8 inches) with anchoring devices suitable for the wall material where the base
unit will be placed.
1
Insert two mounting screws into the wall (with their appropriate anchoring device),
3 & 15/16 inches apart. Allow about 1/8 of an inch between the wall and screw
heads for mounting the telephone.
2
Refer to steps 1 through 7 above for mounting the telephone.
[ 8 ]
To remove, push up
a tab on the wall
mount adapter as
shown.
G e t t i n g S t a r t e d
Advertisement
Table of Contents
