Connecting the Base Unit
1.
Connect the telephone line cord to the "TEL LINE" jack on the base unit and to a telephone
outlet.
2.
Connect the AC adapter to the DC IN 9V jack and to a standard 120 V AC wall outlet.
3.
Set the base unit on a desk or tabletop and place the handset on the base unit.
4.
Raise the antenna to a vertical position.
Before plugging the telephone line into your new telephone, the rechargeable
nickel-cadmium battery pack must be fully charged. Charge the battery for
approximately 15 to 20 hours without interruption.
USING YOUR PHONE
Handset On Base
Remove the handset from the base,
(AutoTalk) or press talk.
1
Remove the handset from the base,
(AutoTalk) or press talk.
2
The talk/battery low LED lights.
3
Listen for the dial tone.
4
Dial the number.
Return the handset to the base,
(AutoStandby) or press talk.
1
Remove the handset from the base,
(AutoTalk) or press talk.
2
Listen for the dial tone.
3
Press redial to dial the last number dialed.
Answer Call
Pick up the handset and press talk.
Make Call
1
Press talk.
2
The talk/battery low LED lights.
3
Listen for the dial tone.
4
Dial the number.
Hang Up
Press talk.
Redial
1
Pick up the handset and press talk.
2
Listen for the dial tone.
3
Press redial to dial the last number dialed.
2
Handset Off Base