Troubleshooting - Hotpoint ENBLH 19xxx FW O3 Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 21
reduce the impact on human health and the environment.
GB
The crossed out "wheeled bin" symbol on the product reminds
you of your obligation, that when you dispose of the appliance
it must be separately collected. Consumers should contact
their local authority or retailer for information concerning the
correct disposal of their old appliance.
Respecting and conserving the
environment
• Install the appliance in a fresh and well-ventilated room. Ensure
that it is protected from direct sunlight and do not place it near
heat sources.
• Try to avoid keeping the door open for long periods or opening
the door too frequently in order to conserve energy.
• Do not fill the appliance with too much food: cold air must
circulate freely for food to be preserved properly. If circulation
is impeded, the compressor will work continuously.
• Do not place hot food directly into the refrigerator. The internal
temperature will increase and force the compressor to work
harder and will consume more energy.

Troubleshooting

If the appliance does not work, before calling for Assistance (see
Assistance), check for a solution from the following list.
Any indicator lights do not illuminate.
• If the function I Care is not active (see section), the plug has not
been inserted into the electrical socket, or not far enough to
make contact, or there is no power in the house.
The motor does not start.
• The appliance comes with a motor protection control (see
Start-up and use).
The indicator lights are on but the light is dim.
• Pull out and reverse the plug before putting it back in the socket.
a) The alarm sounds.
• The refrigerator door has remained open for more than two
minutes (the buzzer will stop sounding when you shut the door)
or the correct switching-off procedure was not followed (see
Maintenance).
b) The alarm sounds and the two blue indicator lights flash.
• The temperature in the freezer is too high. Check the quality
of the food products and dispose if necessary.
+ buzzer =
c) The alarm sounds and the two yellow indicator and one
blue lights flash.
• The temperature in the freezer has reached a dangerous level.
The food must be disposed immediately.
+ buzzer = Heating danger
b/c) In both these cases the freezer will maintain a temperature
of about 0°C so that the food does not re-freeze.
To turn off the acoustic signal open and close the refrigerator door.
restore normal operation product should be switched off and
switched on by buttons from control panel (See the description)
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
24
Heating is excessive
-26
+8
• The doors are opened too frequently.
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The temperature is not adjusted properly (see description)
• The food is near the back inside wall of the refrigerator.
The motor runs continuously.
• The SUPER FREEZE button has been pressed (rapid freezing):
the blue SUPER FREEZE light is on (see Description).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface (see
Installation).
• The appliance has been installed between cabinets that vibrate
and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.

Advertisement

Table of Contents
loading

Table of Contents