Tilt And Swivel; Remove Monitor Stand For Mounting - NEC MultiSync LCD1550X LCD1550X LCD1550X User Manual

Tilt and Swivel

Grasp both sides of the monitor screen with
your hands and adjust the tilt and swivel as
desired (Figure TS.1).
Remove Monitor Stand for
Mounting
To prepare the monitor for alternate mounting
purposes:
1. Disconnect all cables.
2. Place hands on each side of
the monitor and lift up to the highest position (Figure RL.1).
3. Place monitor face down on a non-abrasive surface. (Place the screen on
a 2-inch platform so that the stand is parallel with the surface.)
(Figure S.1)
4. Remove the stand cover by sliding the top/bottom pieces off the stand
(Figure S.2). Remove the 4 screws connecting the monitor to the stand
and lift off the stand assembly (Figure S.3). The monitor is now ready for
mounting in an alternate manner.
5. Reverse this process to reattach stand.
NOTE: Use only VESA-compatible alternative mounting method.
Caution: Please use the attached screws (4 pcs) when mounting. To fulfil the safety requirements
the monitor must be mounted to an arm which guaranties the necessary stability under
consideration of the weight of the monitor. The LCD monitor shall only be used with an
approved arm (e.g. GS mark).
LCD1550X.P65
–continued
Figure S.1
Figure S.2 and Figure S.3
6
6
Figure TS.1
10/10/01, 3:24 PM