NEC MultiSync LCD1550X LCD1550X LCD1550X User Manual page 5

To attach the MultiSync
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI-A signal cable to
the connector of the display card in your system (Figure A.2).
For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the
15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
NOTE: To obtain the MultiSync Macintosh cable adapter call NEC-Mitsubishi Electronics Display of
America, Inc. at (800) 632-4662.
3. Remove connector cover. Connect the DVI signal cable to the connector on the back of
the monitor. Place the video signal cable (Figure C.1). Replace the connector cover.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/
components of LCD module and/or shorten the module's life.
4. Connect one end of the power cord to the AC inlet on the back of the monitor and the
other end to the power outlet (Figure C.1).
NOTE: If you use this monitor at AC220-240V, please refer to Recommended Use
section of this manual for proper selection of AC power cord.
5. The Vacation Switch on the right side of the monitor must be turned on. Turn on the
monitor with the front power button (Figure D.1) and the computer.
NOTE:
The Vacation Switch is a true on/off switch. If this switch is on the OFF position, the
monitor cannot be turned on using the front button. DO NOT switch on/off repeatedly.
6. No-touch auto adjust automatically adjusts the monitor to optimal settings upon initial
setup for most timings. For further adjustments, use the following OSM
• Auto Adjust Contrast
• Auto Adjust
Refer to the Controls section of this User 's Manual for a full description of these
OSM controls.
NOTE: For download information on the Windows
LCD monitor, refer to the References section of this User's Manual.
1550X
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
NOTE: Refer to User 's Manual in the NEC LCD Setup Software CD case for installation and operation
of this software.-
Figure A.1
LCD1550X.P65
LCD monitor to your system, follow these instructions:
®
® 95/98/2000/XP INF file for your MultiSync
3
3
™ controls:
Figure A.2
10/10/01, 3:24 PM