Raid Arrays - SIIG UltraATA 133 PCI RAID Quick Installation Manual

3. Install the hard disk drive to your computer. Attach
the end connector of the Ultra ATA cable to the
connector on the hard disk drive. Make certain that
pin 1 on the cable (indicated by the stripe) matches
pin 1 on the hard disk drive's connector. The same
procedure applies when making connection to IDE2.
Note: The ribbon cable has two connectors. If you
have one hard disk drive, connect it to the end
connector of cable. If you have a second hard disk
drive, connect it to the middle connector of cable.
End Connector
Internal
Drive 1
Drive 1
4. Reconnect the system power and other peripherals
to your computer.

RAID Arrays

RAID Arrays are setup in the UltraATA 133 PCI RAID's
BIOS. Find your RAID set and follow the steps in the
order in which they appear.
RAID 0 (striping) .............................................. page 6
RAID 1 (mirroring) ........................................ page 7-9
RAID 0+1 (mirror+striping) .................... page 10-11
Deleting RAID Arrays ................................... page 12
Resolving Conflicts ........................................ page 12
Middle Connector
Internal
Drive 2
(If Any)
Drive 2
Figure 3. Connecting Internal Drives
IDE1
IDE2
UltraATA 133 PCI RAID
5