Table Of Contents - SIIG UltraATA 133 PCI RAID Quick Installation Manual

Deleting RAID Arrays
1. As the BIOS boots press F3 when prompted to enter
the RAID BIOS.
2. Press F1 to dissolve a RAID set.
3. Enter the number of the RAID set to be deleted.
4. Answer Y to remove the RAID set.
5. Press ESC when finished to reboot.
Resolving Conflicts
If after a disk failure, the replacement disk was previously
part of a RAID set (or used in another system), it may have
conflicting metadata, specifically in reference to the drive
connection information. If so, this will prohibit the RAID
set from being either created or rebuilt, in order for the
RAID set to function properly, this old metadata must be
first overwritten with the new metadata. To resolve this,
press F4, the correct metadata, including the correct drive
connection information, will be written to the replacement
disk.
Software Installation
This section provides information on how to install the
UltraATA 133 PCI RAID drivers.
Windows 98SE ............................................. page 13-14
Windows ME ............................................... page 14-15
Verify Windows 98SE.ME Installation ......... page 15
Windows NT 4.0 ......................................... page 15-17
Verify Windows NT Installation .............. page 16-17
Windows 2000 ............................................. page 17-18
Windows XP/Server 2003 ......................... page 18-19
Verify 2000/XP/2003 Installation .................. page19
12

Table of Contents