How Do I Tell Whether I Have A Gen2E Product; Using The Proliant Guide With Hp D2D4312, Eh983B, Models - HP StoreOnce D2D Backup System Gen2E Maintenance And Service Manual

Table of Contents

How do I tell whether I have a Gen2E product?

The Summary Page of the Web Management Interface will tell you the Type of product.

The product model number also identifies whether it is a Gen2E product, see Table 1 above. This

number can be found on the product label (you may need to remove the product from the rack to

locate the label).

When using the HP ProLiant DL370 G6 guide, be aware of the following HP D2D-specific

information:

The CPU is Intel Xeon W5690 (Kit part number 625071-B21 includes Heatsink) – there are

two per system.

The HP D2D has 12 removable hard disks. The 12th disk is an online spare disk. If one of

the other disks fails, the online spare disk immediately takes its place.

The system comes with three RAID controller cards — the HP Smart Array P410i (integrated

into the Motherboard and with FBWC) and two HP Smart Array P41 1 cards (each with a

512MB FBWC module). The P41 1 cards are installed in PCI-e Slots 5 and 6. Part numbers

for the P41 1 card are as follows:

◦

HP Smart Array P41 1/512 MB with FBWC Controller: 578229-B21

◦

HP 512 MB Flash Backed Write Cache (FBWC): 534916–B21

For more information about the HP Smart Array cards, search on

manuals.

The configuration of the system memory is 96 GB (12 x 8 GB DIMMs, 6 per processor). The

part number for each 8 GB DIMM is 500662-B21.

The system has an HP 8Gb Dual Channel PCI-e to Fibre Channel Host Bus Adapter, part

number AJ764A.

The system has an HP NC522SFP Dual Port 10GbE Server Adapter, part number 614202-B21.

The system has an HP SAS Expander Card, part number 468406-B21, in PCI-e Slot 1.

Introduction

http://www.hp.com/support/

Table of Contents