J27 Settings (Hp D2D4106/41 12 And Hp D2D2502/2504); After Replacing The Motherboard - HP StoreOnce D2D Backup System Gen2E Maintenance And Service Manual

3. Enter the Smart Array POST ORCA utility by pressing [F8] when advised during the POST
messages.
4. Select the Manage Licenses option in the Smart Array menu, and then select View Licenses.
5. Make a note of the licence key reported. This key is unique to the system and can be used
for any replacement Smart Array card (or HP D2D4312 motherboard).

J27 settings (HP D2D4106/41 12 and HP D2D2502/2504)

NOTE: This section is not relevant for HP D2D4312 models.
The following diagram shows the location of the J27 jumper on the motherboard.
Figure 7 Location of the J27 jumper
1 J27 jumper
When replacing the motherboard on HP D2D4106/41 12 models or on HP D2D2502/2504
models, set the jumper as follows.
Table 2 J27 jumper settings
D2D Backup System
HP D2D4106/41 12:
Remove all jumpers
HP D2D2502/2504:
Jumper should be set on pins 1 and 2

After replacing the motherboard

For all Gen2e products you must:
14 Replacing the system motherboard