Access Panel; Front Bezel - HP ProDesk 400 G3 Small Form Factor Maintenance And Service Manual

Access panel

1. Prepare the computer for disassembly
2. Loosen the thumbscrew on the rear of the computer (1) then slide the panel back (2) and lift if off the
computer (3).
To install the access panel, reverse the removal procedure.

Front bezel

1. Prepare the computer for disassembly
2. Remove the access panel
3. Lift up the three tabs on the top side of the bezel (1), and then rotate the bezel off the chassis (2).
NOTE:
make the tabs easier to access.
To install the front bezel, reverse the removal procedure.
18 Chapter 4 Removal and replacement procedures: Small Form Factor
(Access panel on page
You may need a tool to pry up the three bezel tabs, or you can remove the hard drive cage to
(Preparation for disassembly on page
(Preparation for disassembly on page
18).
17).
17).