Setting The Maximum Number Of Authentication Request Attempts; Setting The 802.1X Authentication Timeout Timers - HP 5920 Series Configuration Manual

Step
3. Set the maximum number of
concurrent 802.1X users on a
port.
Setting the maximum number of authentication
request attempts
The network access device retransmits an authentication request if it receives no response to the request
it has sent to the client within a period of time (specified by using the dot1x timer tx-period
tx-period-value command or the dot1x timer supp-timeout supp-timeout-value command). The network
access device stops retransmitting the request if it has made the maximum number of request transmission
attempts but still receives no response.
To set the maximum number of authentication request attempts:
Step
1. Enter system view.
2. Set the maximum number of attempts for
sending an authentication request.

Setting the 802.1X authentication timeout timers

The network device uses the following 802.1X authentication timeout timers:
Client timeout timer—Starts when the access device sends an EAP-Request/MD5 Challenge packet
•
to a client. If no response is received when this timer expires, the access device retransmits the
request to the client.
Server timeout timer—Starts when the access device sends a RADIUS Access-Request packet to the
•
authentication server. If no response is received when this timer expires, the access device
retransmits the request to the server.
You can set the client timeout timer to a high value in a low-performance network and adjust the server
timeout timer to adapt to the performance of different authentication servers. In most cases, the default
settings are sufficient.
To set the 802.1X authentication timeout timers:
Step
1. Enter system view.
2. Set the client timeout
timer.
3. Set the server timeout
timer.
Command
dot1x max-user user-number
[ interface interface-list ]
Command
system-view
dot1x retry max-retry-value
Command
system-view
dot1x timer supp-timeout
supp-timeout-value
dot1x timer server-timeout
server-timeout-value
68
Remarks
The default maximum number
of concurrent 802.1X users on
a port is 256.
Remarks
N/A
The default setting is
2.
Remarks
N/A
The default is 30 seconds.
The default is 100 seconds.