HP 5920 Series Configuration Manual page 23

No. Attribute
61 NAS-Port-Type
79 EAP-Message
80 Message-Authenticator
87 NAS-Port-Id
HP proprietary RADIUS sub-attributes
No. Sub-attribute
1 Input-Peak-Rate
2 Input-Average-Rate
3 Input-Basic-Rate
4 Output-Peak-Rate
5 Output-Average-Rate
6 Output-Basic-Rate
15 Remanent_Volume
20 Command
24 Control_Identifier
Description
Type of the physical port of the NAS that is authenticating the user. Possible
values include:
•
15—Ethernet.
•
16—Any type of ADSL.
•
17—Cable. (With cable for cable TV.)
•
19—WLAN-IEEE 802.1 1.
•
201—VLAN.
•
202—ATM.
If the port is an ATM or Ethernet one and VLANs are implemented on it, the
value of this attribute is 201.
Used to encapsulate EAP packets to allow RADIUS to support EAP
authentication.
Used for authentication and verification of authentication packets to
prevent spoofing Access-Requests. This attribute is present when EAP
authentication is used.
String for describing the port of the NAS that is authenticating the user.
Description
Peak rate in the direction from the user to the NAS, in bps.
Average rate in the direction from the user to the NAS, in bps.
Basic rate in the direction from the user to the NAS, in bps.
Peak rate in the direction from the NAS to the user, in bps.
Average rate in the direction from the NAS to the user, in bps.
Basic rate in the direction from the NAS to the user, in bps.
Total remaining available traffic for the connection, in different units for
different server types.
Operation for the session, used for session control. Possible values
include:
•
1—Trigger-Request.
•
2—Terminate-Request.
•
3—SetPolicy.
•
4—Result.
•
5—PortalClear.
Identification for retransmitted packets. For retransmitted packets of the
same session, this attribute must take the same value. For retransmitted
packets of different sessions, this attribute can take the same value. The
client response of a retransmitted packet must also carry this attribute
and the value of this attribute must be the same.
For Accounting-Request packets of the start, stop, and interim update
types, the Control-Identifier attribute does not take effect.
15