Quick Start - NEC MultiSync JC-1941UMA User Manual

Quick Start

To attach the MultiSync
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync E
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync E
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync E
NEC Technologies at (800) 820-1230.
4. Connect one end of the power cord to the MultiSync E
other end to the power outlet (Figure C.1).
5. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
Untitled-1
E monitor to your system, follow these
® ™
900
Macintosh cable adapter (not
900
Macintosh cable adapter, call
900
Captive Signal Cable
Figure A.1
2
4
monitor and the
900
15-pin mini D-SUB
6/15/98, 1:24 PM
900