Filter Cartridge Replacement - Culligan WH-S100-O Installation And Operation Instructions Manual

FILTER CARTRIDGE REPLACEMENT

• Note differences between WH-S100-O and WH-S200-C.
1 WH-S100-O
OPEN
Turn off water supply to filter.
Press red pressure-relief button to relieve
pressure. Unscrew bottom of housing. Remove
O-Ring from groove in housing and wipe clean
and set aside. Discard used cartridge.
Rinse out housing and fill 1/3 with water.
Add 2 tablespoons of bleach and scrub with
nonabrasive brush or sponge. Rinse thoroughly.
2
Lubricate O-Ring with a coating of clean
food-grade silicone grease. Insert O-Ring back
into groove and smooth into place with finger.
NOTE: This step is important to ensure proper
housing seal. Make certain O-Ring is seated
level in the groove.
Insert new cartridge into housing.
Make certain it slips over the standpipe
at the bottom of the housing.
1 WH-S200-C
OPEN
Turn water off by rotating bypass valve to
"Off" or "Bypass."
NOTE: Turning bypass to "Off" will shut off all
water flow within the household.
Press red pressure-relief button to relieve
pressure. Unscrew bottom of housing. Remove
O-Ring from groove in housing and wipe clean
and set aside. Discard used cartridge.
Rinse out housing and fill 1/3 with water.
Add 2 tablespoons of bleach and scrub with
nonabrasive brush or sponge. Rinse thoroughly.
8