Connecting To A Tv (For U.s.) - NEC MultiSync LCD4020 User Manual

Connecting to a TV* (For U.S.)
Initial TV Setup
Before watching TV for the first time it is necessary to
program the channels.
1. Attach the cable or antenna to the coaxial RF Connector
on the side of the monitor.
NOTE: Cable distribution system should be grounded
(earthed) in accordance with ANSI/NFPA 70, the
National Electric Code (NEC), in particular section
820.93, Grounding of Outer Conductive Shield of a
Coaxial Cable.
2. Enter the OSD and go to the TUNER menu below.
3. In the TUNING BAND menu select which tuning method
(Air, Cable, Cable HRC, Cable IRC) will be used.
4. Enter the CHANNEL SEARCH menu. Press SET to
automatically scan and store channels to memory.
The channel search will store both analog and digital
channels.
NOTE: Analog channels are indicated with a -0 following
the channel number. Digital channels are indicated
with a - followed by a number. For example,
channel 2-0 is analog and channel 2-1 is digital.
Analog channels may also have separate digital
subchannels associated with them. For example
channel 3-0 would be analog followed by channel
3-1, 3-2, etc.
TV TUNER TUNER
Not all models
TUNING BAND
have the Digital
Tuner installed.
CHECK DTV SIGNAL
CHANNEL SEARCH
ADD ON CHANNEL
SEARCH
FINE TUNING
CHANNEL EDIT
CHANNEL LABELS
CONFIGURATION
MENU LANGUAGE
TIME ZONE
PASSWORD SET
PARENTAL CONTROL
PARENTAL
CONTROL MENU
ADVANCED
RATING
CLOSED CAPTION
OPTIONS
RESOLUTION
AUDIO
AUDIO LANGUAGE
DIGITAL AUDIO
OUTPUT
* The product you purchased may not have this feature.
5. Once channels are in memory, use the CHANNEL EDIT
Parental Controls (TV, VIDEO input only)
Parents can block certain types of programming based on
rating and the content.
To block programming:
1. Enter the PARENTAL CONTROL menu, found under the
2. Enter the password. Default password is 0000. This
3. Highlight the square next to the type of programming you
NOTE: Blocking one type of programming will
TV TUNER
Choose AIR or Cable as TV source.
Shows the status of the Digital TV signal.
Searches for TV channels and stores them in memory.
Searches for TV channels and stores them in memory without erasing previously stored channels.
Performs fine adjustments to analog channels.
Add or remove channels stored in memory.
Add a label to the channel.
Set the Parental Control Password. Factory default password is 0000.
Parents can choose to block types of programming based on rating and content.
Downloadable rating, depending on broadcast. Press SET to change setting.
NOTE: Closed captioning settings can not be adjusted for the VIDEO/S-VIDEO inputs.
AUTOMATIC is is the only option available for these inputs.
Set the displayed image to the desired resolution.
Choose the language of audio output.
Select the digital audio output source. Choose Dolby D/PCM/OFF.
English-30
menu to add or remove channels. Use the CHANNEL
LABELS menu to create unique names for channels, if
desired.
CONFIGURATION submenu within the TUNER OSD.
password can be changed in the PASSWORD SET
menu.
wish to block and press SET on the remote.
automatically block all higher rated programming
also. However, it is possible to unlock this
programming while keeping the desired
programming blocked.