Configuration
DI and DO
This camera has a general I/O terminal block with one digital input and digital
output for device control. The I/O connector provides the physical interface for
digital input (DI+, GND) and digital output (DO+, GND) that is used for connecting a
variety of external alarm devices to the camera such as IR-Sensors and alarm relays.
You can configure what the camera will do when a DI signal is detected, or you can
configure when the camera will send a DO signal on the Event Settings page. Please
refer to "Event Settings" on page 58 for more detailed information.
D-Link DCS-7517 User Manual
57