Redsail C series User Manual page 32

Vinyl not feeding straight and the
rightmost Pinch Roller will not
move.
Cuts are jagged or inconsistent.
Slashes are made across the vinyl
from the blade movement during
cutting.
Other troubleshooting solutions may be found by visiting the Customer
Forums or Technical Support Website, or by calling the Technical
Support Line (Web page addresses and Phone number on the
specifications page, 3).
version number:
Redsail Tech Co., Ltd
www.hflaser.com
1.1.1.140508_PRO
to serial connecter or a PCI card serial
adapter for your computer.
Sometimes, during shipping or movement
of the machine, the right pinch roller will
become stuck on a screw located on the
back of the machine. If this occurs and is
affecting your cutting, press forcefully
against the pinch roller until it becomes
dislodged from its position. If needed,
remove the screw to reposition the pinch
roller in the desired position.
The Blade may be dulled or damaged.
Replace with a new blade and try again.
Make sure that the blade can turn freely
(by attempting to turn it with your fingers
while the release button of the Blade
Carriage is pressed).
Adjust the blade depth of the Blade
Carriage and Force setting on the cutter
until you are getting solid, uniform cuts.
Start with a blade depth of around 1/64
of an inch and a pressure setting of 100g
and try an increased pressure setting
before attempting to increase the blade
depth.
If the blade is protruding too far from the
Blade Carriage then it can score and cut
material during normal operations. If this
is occurring, the blade needs to be
adjusted so that it is protruding a minimal
distance from the carriage.
th
32