Redsail C series User Manual page 13

version number: 1.1.1.140508_PRO
P+ Button
Adjust the cutting force
For increasing the force when online, the highest
force is 500g.
A cutting force of 100g is a good general starting
place to work from when trying to determine the
force needed for a specific material. All cuttable
materials will differ in the amount of force needed so
proper testing should be always made to determine
the amount of force to use. The amount of force used
should be enough to fully penetrate the material to be
cut while not enough to cut through the backing
material.
P+
For moving the carriage arm to the left position when
offline.
P- Button
Adjust the cutting force
For reducing the force when online, the lowest force is
50g.
A cutting force of 100g is a good general starting
place to work from when trying to determine the
force needed for a specific material. All cuttable
materials will differ in the amount of force needed so
proper testing should be always made to determine
the amount of force to use. The amount of force used
should be enough to fully penetrate the material to be
cut while not enough to cut through the backing
material.
P-
For moving the carriage arm to the right position
when offline.
Redsail Tech Co., Ltd
13
www.hflaser.com