Caliber RDD 571BT Instruction Manual page 13

2. BAND BUTTON
In RADIO mode, press the BAND button on the remote
control to select your desired radio band of FM1, FM2, FM3,
AM1 and AM2.
3. TUNE/SEEK UP/DOWN BUTTONS
In RADIO mode:
1) Press and hold the >>|/|<< button on the remote control or the icons
radio interface to automatically search up/down for an available station from
current frequency.
2) Briefly press the >>| / |<< button on the remote control or tap the icons
radio interface to manually search up or down with step by step for your desired
station from the current frequency.
4. APS BUTTON
In RADIO mode:
1)When pressing and holding the APS button on the remote control,the radio searches
from the lowest frequency and checks the signal strength level until 1 cycle search is
stations are preset to the corresponding preset number memory bank. The AS oper-
-ation is finished. And then the 6 strongest implemented in the each bank of the sel-
-ected band. When the AS operation is finished, it will scan each preset station for 5
seconds in FM or AM band from M1 as briefly pressing APS button. After finishing a
circle of scanning , it will resume broadcasting on the M1.
(It can store 3x6 stations for FM and 2x6 stations for AM in all)
2) When briefly pressing the APS button, the radio will scan each preset station for 5
seconds in FM or AM band from M1. After finishing a circle of scanning, it will resume
broadcasting on the M1.
NOTE: In FM band, FM1,FM2,FM3 is checked one at a time; In AM band, AM1, AM2 is
checked one at a time.
5. PRESET STATION [ 1-6 ] BUTTONS
In RADIO mode:
1) To memorize the current frequency on the current band, press and hold any one
of the six preset buttons (1-6) on the remote control or one of the six icons(P1-P6)
in the radio interface.
2) To recall the preset memory on the current band, press one of the preset buttons
[1-6] on remote control or
6. STEREO/MONO BUTTON
Press the ST button on the remote control to select the STEREO or MONO sound
mode for FM band.
7. LOC BUTTON
1) In RADIO mode, when the signals of the distant radio stations are very weak and
the receiving effect is bad during tuning, check whether there is the word LOC on
LCD. If there is the word LOC on LCD, press this button to turn off the LOC
function, then tune again for the distance radio station;
2) In RADIO mode, when the signals of the local radio stations are too strong this
one of the six icons(P1-P6) in the radio interface.
12
in the
in the