Quick Start - NEC MultiSync E1100+ User Manual

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter to the monitor connector
on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the
captive signal cable to the Macintosh cable adapter on the computer (Figure
B.1). Tighten all screws.
4. For download information on the Windows
E + monitor, refer to the References section of this User's Manual.
1100
5. Connect one end of the power cord to the MultiSync E
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
78133724.wpc
E +
®
1100
Figure A.1
5
monitor to your system, follow
™
® 95/98 INF file for your MultiSync
1100
Figure B.1
3
11/18/98, 11:52 AM
+ monitor and the