Troubleshooting
To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the apparatus is
connected properly.
- Ensure that there is power at the AC outlet.
- Press ON/OFF button to turn the unit on.
Remote control does not work
- Before you press any function button, first select
the correct source.
- Reduce the distance between the remote control
and the unit.
- Insert the battery with its polarities (+/-) aligned as
indicated.
- Replace the battery.
- Aim the remote control directly at the ensor on the
front of the unit.
No Response From the Unit
- Disconnect and reconnect the AC power plug, then
turn on the unit again.
Poor radio reception
- Increase the distance between the unit and your TV
or VCR.
- Fully extend the FM antenna.
- Connect an outdoor FM antenna instead.
Timer does not work
- Set the clock correctly.
- Switch on the timer.
Clock/timer setting erased
- Power has been interrupted or the power cord has
been disconnected.
- Reset the clock/timer.
Using iPhone to play music
- While the iPhone is playing the music throught the
docking, there may be a chance that the iPhone
may not be under a good receiption mode to get the
incoming call signal.
20
Specifications
General
Power Requirements
Power Consumption
Output Power
Total Harmonic Distortion
Audio Input Sensitivity/Impedance
Frequency Response
Tuning Range
Unit Dimensions (W x H x D)
Speaker
Front
Impedance
Rate Power
Remote
Distance
Angle
Standard Accessories
Remote Control
Owner's Manual
Design and specifications are subject to change
iPad/iPod/iPhone Speaker