Listening To The Fm Radio; Troubleshooting - VIETA VH-US110SL User Manual

Listening to the FM Radio
Tuning in a Station
1. Ensure that you have connected and fully extended
the FM antenna.
2. Press the FM button to select the FM source.
3. Press the TU-/TU+ buttons, the frequency
changes down or up automatically until a station is
found.
Presetting Stations
You can preset up to 20 FM stations.
Program radio stations automatically

Press and hold the PROG button for 2 seconds
to activate automatic programming. All available
stations are programmed in the order of waveband
reception strength.
- The first programed radio station is played
automatically.
Program radio stations manually

1. Tune in the desired station, then press the PROG
button.
2. Press the / buttons to select the preset
 
number.
3. Press the PROG button to store the station.
4. Repeat above steps 1 to 3 for each station you
want to store in memory with a preset number.
If the system is unplugged or if a power failure
occurs, the preset stations will be erased
unless there are batteries in unit and don't
change batteries at this time.
Tune to a Preset Radio Station
Press the or buttons to select a preset number
 

that you want.

Troubleshooting

To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the apparatus is
connected properly.
- Ensure that there is power at the AC outlet.
- Press ON/OFF button to turn the unit on.
Remote control does not work
- Before you press any function button, first select
the correct source.
- Reduce the distance between the remote control
and the unit.
- Insert the battery with its polarities (+/-) aligned as
indicated.
- Replace the battery.
- Aim the remote control directly at the ensor on the
front of the unit.
No Response From the Unit
- Disconnect and reconnect the AC power plug, then
turn on the unit again.
Poor radio reception
- Increase the distance between the unit and your TV
or VCR.
- Fully extend the FM antenna.
Timer does not work
- Set the clock correctly.
- Switch on the timer.
Clock/timer setting erased
- Power has been interrupted or the power cord has
been disconnected.
- Reset the clock/timer.
ENGLISH
19