Sony DXC-H10 Operating Instructions Manual page 79

H. PHASE (horizontal phase)
Adjusts the horizontal phase when you use the external sync
signal. The initial setting is 10. Adjustable range is from 0 to
255.
SYNC/VD
Switches the signal 1) output from the Pin 21 on the
CAMERA ADAPTOR connector (26-pin) and from the Pin
7 on the MONITOR connector (D-sub 9-pin).
Selection Function
Outputs the sync signal.
SYNC
Outputs the VD signal.
VD
GBR/YP P
B R
Switches the video signal output from the CAMERA
ADAPTOR connector (26-pin) and the MONITOR
connector (D-sub 9-pin).
Selection Function
Outputs the GBR signal.
GBR
Outputs the YP P signal.
YP P
B R
B R
.................................................................................................................................................................................................................................
1)
You can switch the input and output with the IN/OUT select switch on the rear panel of the CMA-H10 camera adaptor.
Note
If the monitor is equipped with the signal selector, select the
same signal as the GBR/YP P setting on the selector.
B R
FLASH
Sets when you use a flash connected to the FLASH
connector on the rear panel.
Selection Function
Select this setting when using the camera without a
OFF
flash.
Select this setting when you connect a flash to the
ON
FLASH connector, and use an external frame memory,
etc. Synchronized with the input of an external trigger
signal, a flash is emitted and the WE pulse is output.
Use of the WE pulse with an external frame memory
allows you to capture full-frame still images of an HD
signal.
To select this setting, set FLD/FRM in the PAGE 3/3
menu to FRM.
For details, see the timing chart in flash emission on page
26.
Chapter 2 Operation
DXC-H10.3-862-128-01 (3) J/E/F
25
(EN)