BESAFE iZi Combi X1 Isofix User Manual page 55

8
9
Important: The belt loop
must be led into this hook
Remove the plastic
caps (9) from the ISOfix
connectors (7) by pressing
down the ISOfix release
7
button (8).
Use the ratchet (6) to adjust
6
the front brace to the inmost
position. The ratchet (6)
is used to adjust the front
6
brace in both directions.
Switch the knobs on the
ratchet to change direction.
Assemble the floor support
before you install the iZi
Combi ISOfix in your car.
12
The floor support (12)
must go through the belt
loop (14). The belt loop
must also be led into the
hook on the floor support.
Do not fasten the locking
bolt (13) yet.
7