Hitachi PB Series User Manual page 87

Section 5
Two different cursors are available:
Move mode
Displayed:
The cursor is moved to a dot setup position.
Reversal mode
Displayed:
The dots at the positions the cursor is moved to are reversed.
To change the cursor type, press [Invert next].
3. Press [ ] key five times successively.
This moves the cursor to the lower left corner of the matrix.
4. Press [Invert next].
The cursor changes to reversal mode.
The following indications are given.
Dot present:
No dot present:
Press [Clear] to erase the pattern generated in the creation area so far.
5. Press [ ] four times successively.
This moves the cursor toward the right.
5.2 Creating a User Pattern 5–9