Maintenance; Operation - Makita FS4000 Instruction Manual

Fig.8
Grasp the bit with a pair of pliers and pull the bit out of
the magnetic bit holder. Sometimes, it helps to wiggle
the bit with the pliers as you pull.
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the gear housing.
Fig.9
Installing removable cord adapter
For Model FS6300R
Fig.10
Insert the Removable Cord Adapter as far as it goes so
that the marking on an end of the Removable Cord
Adapter on the side of connecting to power supply cord
is aligned to the marking
Removable Cord Adapter on the side of connecting to
the tool.
Turn the Removable Cord Adapter clockwise until it is
locked with a lock button.
Fig.11
And at this time the marking
Removable Cord Adapter on the side of power supply
cord is aligned to the marking
Removable Cord Adapter on the side of connecting to
the tool.
Fig.12
Removing removable cord adapter
Fig.13
Rotate the Removable Cord Adapter counterclockwise
until it stops while pressing the lower part of the lock
button.
Then pull the Removable Cord Adapter in that position.
Fig.14
Use of locator holder
Fig.15
The locator can be temporarily held on the locator holder
during replacing bit or using without locator. To hold the
locator, position the trapezoidal holes of the locator on
the swells of the locator holder and push it in.

OPERATION

Fig.16
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
When fitting the screw onto the point of the bit, be
•
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
on the other end of the
on an end of the
on the other end of the
Make sure that the bit is inserted straight in the
•
screw head, or the screw and/or bit may be
damaged.
Hold the tool only by the handle when performing
•
an operation. Do not touch the metal part.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Phillips Insert bits
•
Magnetic bit holder
•
Locator
•
Plastic carrying case
•
6
or attachments
Only use accessory or
are