Table of Contents
Advertisement
I
NTRODUCTION
This manual will guide you through the following installation requirements:
• Installing the Control Head
• Installing the Transducer
• Connecting Cables to the Control Head
• Connecting the Control Head to Power
• Powering On the Control Head
• Configuring the Control Head and Basic System Setup
P
REPARATION
Before you start the installation, please take a moment to familiarize yourself with the parts
list and supplies list. We also encourage you to read the instructions beforehand so that you
may understand the installation requirements.
NOTE: Product supplies and features are subject to change without notice.
Parts
Your ONIX includes the following items:
A
ONIX control head with cover
B
gimbal mounting bracket with gimbal mounting hardware
C
(2) gimbal knobs
D
(2) urethane washers
E
(4) flat washers
F
(4) 1" - #10 wood screws
G
(4) 1" - split ring cable grommets
H
(1) transducer with transducer mounting hardware
I
power cable
Supplies
In addition to the parts supplied with your installation kit, you will need the following items:
• powered drill with various drill bits
• various hand tools, including
a socket wrench or flat blade screwdriver
ruler, straightedge, or measuring tape
level
12" plumb line (weighted string or monofilament line)
• marker or pencil
• safety glasses
• dust mask
• marine-grade silicone sealant
• dielectric grease (optional)
1
A
B
C
D
E
F
G
H
OR
OR
Side Imaging
DualBeam PLUS
transducers
transducer
I
Introduction
Hide quick links:
Advertisement
Table of Contents
