Humminbird ONIX8 Installation Manual page 27

General Settings | Select Time and Date Format, and Units of Measurement
Select Units of Measurement
1. Select Units and open the submenu.
2. Select a menu option and open the submenu.
3. Select a setting and press the CHECK key
selection.
4. Tap the back arrow on-screen or press the EXIT key
to the submenu.
5. Repeat steps 2 through 4 to change another setting.
6. Tap the back arrow on-screen or press the EXIT key
to the main menu.
7. Select additional settings as needed. Tap the right arrow on-screen
or press the RIGHT ARROW key
next menu dialog box.
Sonar | Confirm Transducer Setup and Set the Depth Offset
The control head will default to the transducer that was included with your unit and automatically select sonar settings based on the
transducer's capabilities. If your control head is compatible with an accessory transducer, and it is connected to the control head, use
Transducer Setup to select the accessory transducer. Use the following instructions to confirm transducer setup and set the depth offset.
Confirm Transducer Setup
1. Select Transducer Setup and open the submenu.
2. Review the current menu settings.
To make changes: Select a setting and press the CHECK key
confirm the selection. If your transducer supports multiple sonar
beams (Side Imaging, Down Imaging, and 2D Sonar), select each
one you plan to use.
3. Tap the back arrow on-screen or press the EXIT key
to the main menu.
Set the Depth Offset
1. Select Depth Offset and open the submenu.
2. Drag the slider, or use the Rotary Dial, to adjust the setting.
3. Tap the back arrow on-screen or press the EXIT key
to the main menu.
4. Select additional settings as needed. Tap the right arrow on-screen
or press the RIGHT ARROW key
next menu dialog box.
to confirm the
to return
to return
on the keypad to proceed to the
to return
to return
on the keypad to proceed to the
menu options
to
23
current menu option setting submenu
current menu option setting submenu
current menu option setting
Setup Guide
back