Attaching The Carrying Cord; Inserting And Changing The Batteries - Leica RANGEMASTER CRF 1600-B Instructions Manual

aTTaching The carrying cOrd

Feed the small loop on the carrying cord through the
eyelet (4) on the housing of the Leica Rangemaster CRF
1600-B. Then thread the end of the cord through the
small loop and pull tight, so that the resulting loop is
securely around the eyelet on the housing.

inSerTing and changing The BaTTerieS

The Leica Rangemaster CRF 1600-B is powered by a 3
Volt lithium round cell (e.g. Duracell DL CR2, Ucar CR2,
Varta CR2, or other CR2 types).
1. Open the cover (6) on the battery compartment (7) by
turning it anticlockwise.
2. Insert the battery so that the positive contact goes
in first (as shown by the markings in the battery
compartment).
3. Close the cover again by turning it clockwise.
26