Printing A Proof Print - Primera CX1000 Operator's Manual

TOC
4. Click the Quote Tool Tab (fourth tab down with the coin icon). Your total cost per label
including stock will be displayed based on default toner cartridge and stock costs. Adjust these
values to reflect the actual cost of your toner and label stock.
Once you set the stock and toner cost values you will not have to change them again unless you
make another purchase of stock or toner at a different cost.
Important Note: This tool provides a Cost ESTIMATE. Actual costs may vary.
Labels Per Page
Always verify the labels per page is accurate. Adjust if necessary. If you manually array images on a
page in PTPrint using the instructions in Section 5.2, the Labels Per Page will have to be manually
entered.
Print or Save Quote
You can print this screen and attach it to the proof print and/or Save the screen capture as a JPG to
keep with the original PTPrint file. Simply click the Print button or the Save button.

6.2 Printing a Proof Print

Immediately before you print any job you can print one page of that job (Proof Print). If you print a
proof print you can:
•
estimate cost per label
• enable analysis of available toner in cartridges vs. required toner to finish the job
Even if you have previously printed a one page proof print to estimate label cost you must always
print a one page job immediately before your job to check if there will be enough toner for your job.
See the flow chart below for a typical work flow.
Note: To require a proof print before
printing set the "Enable Proof Print"
box on the settings tab (third tab
down).
Proof Print Required
Print
if First Time
Printing Label
Sufficient Media
Subsequent Print
Insufficient Media
Job Finishes
Print Reduced Job Finishes
Amount (Reduced Amount)
Continue Printing Job Stops after
with current media media depletion
1. Cancel Job 1. Replace low media
2. Print Supplies Sheet 2. Print Again
Toner Monitoring and Supply Management 29
INDEX
Job Finishes