Sony BDP-CX7000ES Service Manual page 5

QQ
3 7 63 1515 0
ALIGNMENT OF GEAR (CAM) PHASE WITH DOOR ASSY
door assy
Align a slit of door assy with a marking on
the bottom land of gear tooth when the gear
is rotated fully in arrow direction, as shown.
MB-124-MEGA-EJ AND VP-062EJ BOARDS SERVICE POSITION
• It is necessary to connect MB-124-MEGA-EJ board (CN904) and IMD (ES) board (CN3005) with the extension cable to do the setting
to this position.
Prepare the following extension cables.
Part No. J-2501-068-A (19 pin, 1.00 mm pitch)
TE
L 13942296513
Connect jig (extension cable)
to the IMD board (CN3005)
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, for the electric shock prevention, con-
nect the resistors to both ends of respective capacitor (C106) to
discharge the capacitor (C106).
– Switching Regulator (Conductor Side) –
www
.
http://www.xiaoyu163.com
gear (cam)
800 /2 W
x ao u163
y
C106
i
http://www.xiaoyu163.com
2 9
8
MB-124-MEGA-EJ board
CN904
Q Q
3 6 7 1 3
HARNESS SETTING ON SWITCHING REGULATOR
Note: This illustration sees the switching regulator from component side.
.
clamp (L35)
BDP-CX7000ES
9 4 2 8
VP-062EJ board
1 5 0 5 8 2 9 9 4
insulation
harness
m
co
AC inlet (2P) harness
9 9
2 8 9 9
wire
switching
regulator
5