Machine Maintenance Recommendations - Nautilus S912 Owner's Manual

MAINTENANCE

Machine Maintenance Recommendations

Congratulations on choosing the Nautilus
condition is important to you and your customers, so please take a few minutes to read the following maintenance instructions.
Parts & Services
Regular and scheduled maintenance will prolong the life of your Nautilus
only genuine Nautilus parts. The Nautilus Customer Service Team invites you to call in your order for replacement parts. They're
®
never too busy to discuss or offer a tip on your maintenance tasks.
Nautilus machines – the culmination of years of research and refinement – are made from the highest quality materials, under
®
exacting conditions. The quality control tag attached to each machine before shipping ensures that each unit has been thoroughly
inspected to meet Nautilus' strict requirements.
Should you, the owner of a Nautilus
machine ever need maintenance, Nautilus invites you to call our Customer Service department for information on parts and
service.
Call 1-800-NAUTILUS
General Maintenance
Frequency of maintenance is determined by several factors: temperature, humidity, use, ventilation and filtration, shielding and
friction. External maintenance may vary from daily to monthly, internal maintenance from six months in a high-use environment to
a year when used in a lower use setting.
Do not place equipment in direct sunlight as ultra violet rays can damage shields and upholstery.
1. SPOT CHECK LOOSE NUTS AND BOLTS
• Carefully check rotation points.
• Tighten loose parts immediately. Also check for worn parts, seat belts and upholstery pads.
2. SPOT CHECK CABLES AND PULLEYS
• The system is set up properly when the cables are taut and the pins engage easily into the weight stacks. If cables or
pulleys appear to have any damage, including gouges, bulging, discoloration or any wires are exposed, DO NOT USE
MACHINE.
3. UPHOLSTERY PAD TIGHTENING
• Most bolts on upholstery pads can be tightened with a 9/16" combination wrench.
Lubrication
MOVING PARTS
• To clean guide rods, wipe down with a clean cloth and an ammonia-based cleaner. Wipe completely dry. Spray a
generous amount of silicone lubricant on the rods.
• Apply silicone spray onto the guide rods whenever there is any evidence of sticking between the guide rods and the
weight plate bushings.
30
S912 Strength System. We know that keeping your equipment in the best working
®
machine, need to replace any parts because of normal wear and tear, or should your
®
equipment. Should you have to replace parts, use
®