Using The Appliance - Silvercrest SNHT 1.5 B2 Operating Instructions Manual

3) Close the battery compartment
compartment cover 6 at an angle on the battery compartment 5,
so that the spot on the battery compartment cover 6 lies under
the opened lock on the hand element 4
compartment cover 6 until the spot lies under the closed lock on
the hand element

Using the appliance

Trimming nose hairs
1) Remove (if fi tted) the comb attachment
head 1.
2) Slide the on/off switch
WARNING - RISK OF INJURY
► Do not insert the cutting head
NOTICE
► Ensure that your nostrils are clean.
3) Guide the cutting head
turn the appliance so that all nose hair growth is removed.
4) Withdraw the cutting head
appliance.
5) Switch the appliance off by sliding the on/off switch
Trimming eyebrows
1) Affi x the desired comb attachment (4 mm
cutting head 1 so that it is fi rmly seated.
2) Slide the on/off switch
3) To trim all of the hair of the eyebrow, move the comb attachment
7/8 over the eyebrow and against the direction of hair growth.
4) To trim only individual hairs, move the comb attachment
over the eyebrow and only against these individual hairs.
5) In order to trim hair to just above the skin surface, remove the
comb attachment 7/8 and guide the cutting head 1 directly
over the skin in the desired areas.
6) Switch the appliance off by sliding the on/off switch
SNHT 1.5 B2
5. To do this, place the battery
.
7/8 from the cutting
3 upwards.
1 too deeply!
1 carefully into the nostril and slowly
1 out of the nostril whilst turning the
3 upwards.
. Turn the battery
3 downwards.
7 or 7 mm 8) to the
7/8
3 downwards.
GB
MT
43