Signal Connections; I/O Connector - National Instruments PC-LPM-16/PnP User Manual

Signal Connections

I/O Connector

Warning: Connections that exceed any of the maximum ratings of input or output
National Instruments Corporation
This chapter describes how to make input and output signal connections
to your PC-LPM-16PnP board via the I/O connector.
Figure 4-1 shows the pin assignments for the PC-LPM-16PnP
I/O connector. This connector is located on the back panel of the board
and is accessible from the back of your computer after you have
properly installed the board. Installation instructions are in Chapter 2,
Installation and Configuration.
signals on the PC-LPM-16PnP can damage the board and the computer.
This includes connecting any power signals to ground and vice versa. Each
signal description in this section includes information about maximum
input ratings. National Instruments is
from any such signal connections.
liable for any damages resulting
NOT
4-1
Chapter
4
PC-LPM-16/PnP User Manual