National Instruments NI-488.2 NI-488.2 User Manual page 69

Table 7-3. Syntax for Multi-Device NI-488.2 Calls in Interactive Control
Syntax
AllSpoll addrlist
DevClear address
DevClearList addrlist
EnableLocal addrlist
EnableRemote addrlist
FindLstn padlist limit
FindRQS addrlist
PassControl address
PPoll
PPollConfig address dataline
lineSense
PPollUnconfig addrlist
RcvRespMsg count termination
ReadStatusByte address
Receive address count termination
ReceiveSetup address
ResetSys addrlist
Send address buffer eotmode
SendCmds buffer
SendDataBytes buffer eotmode
SendIFC
SendList addrlist buffer eotmode
SendLLO
SendSetup addrlist
SetRWLS addrlist
TestSRQ
© National Instruments Corporation
Description
Serial poll multiple devices.
Clear a device.
Clear multiple devices.
Enable local control.
Enable remote control.
Find all Listeners.
Find device asserting SRQ.
Pass control to a device.
Parallel poll devices.
Configure device for parallel poll.
Unconfigure device for parallel poll.
Receive response message.
Serial poll a device.
Receive data from a device.
Receive setup.
Reset multiple devices.
Send data to a device.
Send command bytes.
Send data bytes.
Send interface clear.
Send data to multiple devices.
Put devices in local lockout.
Send setup.
Put devices in remote with lockout state.
Test for service request.
7-9
Chapter 7 Interactive Control Utility
NI-488.2 User Manual