Canon Pixma MX700 Quick Start Manual page 9

4
Install the ink tanks.
Important
Make sure that all the ink tanks are installed in the correct position, matching the label. The
machine cannot be used unless all the ink tanks are installed.
Wait for about 2 minutes, until the machine has stopped making operating noises, before
proceeding.
Note
Be sure to remove the clear film from the ink tank in the exact order as shown in step 3 of your
setup sheet.
Do not squeeze the side of ink tanks as this may cause the ink to leak out and stain your clothes
and hands.
An error message will be displayed on the LCD if an ink tank is not installed properly. Open the
Scanning Unit (Printer Cover) and make sure that position of all the ink tanks match the label.
After the ink tanks are installed, align the print head if lines or colors are off. Refer to "Aligning
the Print Head" in the User's Guide on-screen manual.
For fax users
Select the receive mode according to your needs. See "Selecting a Receive Mode" on page 35.
When you have a dedicated telephone line for fax use only:
Select FAX only mode.
When you are using a single telephone line for faxes and voice calls:
If you receive mainly voice calls and sometimes faxes, select TEL priority mode.
If you receive mainly faxes and sometimes voice calls, select FAX priority mode.
When you subscribe to a ring pattern detection service provided by your telephone company. (Not
available depending on the country or region of purchase.):
Select DRPD or Network switch.
Note
To receive a fax, you need to set the telephone line type setting properly on the machine. For details on
how to confirm and change this setting, refer to the User's Guide on-screen manual.
If you are unsure of your telephone line type, contact your telephone company.
Preparing the Machine 5