Canon Pixma MX700 Quick Start Manual page 43

(4) Remove the orange protective cap (F) from the
bottom of the ink tank.
Carefully hold the protective cap when
removing it to prevent the ink from staining
your fingers.
Discard the cap once it is removed.
Important
Do not touch the electrical contacts (G) on the ink
tank. Doing so can cause the machine to
malfunction or become unable to print.
5
Insert the front end of the ink tank into the
Print Head.
Make sure the position of the tank matches the
label (H).
6
Press on the
the ink tank snaps firmly into place.
Confirm that the ink lamp (I) lights up red.
7
Lift the Scanning Unit (Printer Cover) slightly to set the Scanning Unit Support back
to its original position, and then gently close the Scanning Unit (Printer Cover).
Note
If you have pressed the Stop/Reset button for at least 5 seconds when "The remaining level of the ink
cannot be correctly detected." or "The ink has run out. Replace the ink tank." appears on the LCD,
note the following.
When ink runs out, printouts will become faint or blank printouts will be printed.
When receiving faxes, the machine will not store it in its memory even if the ink level becomes low or
run out.
mark on the ink tank until
Replacing an Ink Tank
(F)
(G)
(H)
(I)
39