Plug In The Power To Charge The Battery - First Data FD400 Quick Setup Manual

Plug in the power
to charge the battery
Install the battery into the terminal, then connect the power cord to
the power to charge the battery. It can take up to 4 hours to fully
charge the battery. Once the battery is fully charged, the FD400
Ti
can run on battery power for several hours before requiring a new
charge. Find the power button on the front of the terminal.
Caution: The battery pack cover should be kept closed during
normal operation.
Caution: Risk of explosion if the battery is replaced by an incorrect
type. Please dispose of used battery according to the instructions.
Note: Make sure the battery is installed in the terminal before
connecting to the power supply to charge.
Power Button
Warning: A shielded-type power cord is required in order to
meet FCC emission limits and also to prevent interference with
nearby radio and television reception. It is essential that only the
supplied power cord be used.
5