Table of Contents
Advertisement
Chapter 2
Hardware Installation
Do not raise the injector/ejector handle as you insert the NI PXI-8360 or
Caution
NI PXIe-8360. It will not insert properly unless the handle is in its downward position so
that it does not interfere with the injector/ejector rail on the chassis, as shown in Figure 2-2.
NI ExpressCard MXI Series User Manual
4.
Make sure the injector/ejector handle is in its downward position.
Be sure to remove all connector packaging and protective caps from
retaining screws on the module. Align the NI PXI-8360 or
NI PXIe-8360 with the card guides on the top and bottom of the system
controller slot.
5.
Hold the handle as you slowly slide the module into the chassis until
the handle catches on the injector/ejector rail.
6.
Raise the injector/ejector handle until the module firmly seats into the
backplane receptacle connectors. The front panel of the NI PXI-8360
or NI PXIe-8360 should be even with the front panel of the chassis.
7.
Tighten the bracket-retaining screws on the top and bottom of the front
panel to secure the NI PXI-8360 or NI PXIe-8360 to the chassis.
8.
Replace or close any doors or covers to the chassis.
2-2
ni.com
Advertisement
Table of Contents
