Worx WG785E Manual page 14

STOPPING
Release the switch lever.
2. INSTaLLING mULCh INSERT (14) (See h)
1) Turn the mower off, wait until the blade
stops and remove the safety key (6).
2) Raise the safety guard and hold it up.
3) Slide the mulching insert into the discharge
opening until it is firmly in contact with the
deck.
4) Release safety guard and ensure it is
properly closed.
3. REmOVING mULCh INSERT(14) (See h)
To remove the mulching insert so that you can
collect the grass, follow the steps listed below:
1) Shut the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Grasp the middle of the insert, lift and pull
out the mulching insert completely.
4) The safety guard is spring loaded. When
you release it, the guard will return to the
closed position.
14 14
4. wORk mODE DIaL (See I)
Status1: QUIET mode
Select QUIET mode when mowing in everyday
conditions, removing approximately 20mm of
grass at a time.
Status2: TURbO mode
Set the dial to TURBO mode when cutting
dense or overgrown grass.
5. baTTERy STaTUS LED'S (See J)
NOTE: The Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
press the button "pRESS" , the light button is
illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
Cordless Lawn mower
) are illuminated, the
battery is in a moderately charged condition.
When only one green light ( ) is illuminated,
the battery charge is depleted.
Before using your new mower for the first
time, it is recommended that the unit be
charged overnight to ensure that the battery is
fully charged.
ImPORTaNT
when only one light is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.
6. aDJUSTING ThE CUTTING hEIGhT
(See k)
waRNING! Stop, release switch lever and
wait until the motor stops before adjusting
height. The blades continue to rotate after the
machine is switched off, a rotating blade can
cause injury.
CaUTION: Do not touch rotating blades.
For the first cutting of the season, a high
cutting adjustment should be selected. The
lawnmower can be set to 6 cutting heights
between 20mm and 70mm. For this purpose,
move the cutting height adjustment lever
outwards then adjust to the preferred position.
7. GRaSS baG FILLING INDICaTOR (See L)
To remind you immediately to empty when
the grass bag is full, the mower provides
an indicator on the top of bag to show the
collection status. And you can follow as below:
Empty status: flap float (a)
Fully status: flap fall down (b)
8. REaR DISChaRGE (See m)
The mower provides a rear discharge function,
so that you can mower without bag collection.
The debris will be discharged from the rear
chute.
EN