Dip Switches - Westinghouse WBRC**140F Manual

This appliance is equipped with a three prong plug. It should only be plugged directly into a properly grounded three prong receptacle.
DO NOT remove the ground plug from the plug. Doing so could result in property damage, serious personal injury, or death.
2. The wiring diagrams contained in this manual are to be used for reference purposes only.
3. Refer to these diagrams and the wiring diagrams of any external controls used with the installation when wiring the appliance. Read,
understand, and follow all wiring instructions supplied with the controls.
4. Do not disconnect the power supply when the appliance is in normal operation.
NOTE: For additional electrical protection, the use of a surge protector is recommended. Damage caused by power surges is not
covered by the warranty.
Figure 27 – Manual Power Switch and Appliance Plug Details
If the appliance display does not come ON, first check the plug. Then check the electrical panel circuit breaker and reset it if necessary.
If the circuit breaker trips again, do not reset. Disconnect the plug and have a qualified technician diagnose the problem.
C. DIP SWITCHES
There is one set of DIP switches. The appliance is default set at the factory to operate on Natural Gas with a 3" vent.
DIP SWITCH GROUP
DIP SWITCH
1 – 3
4
5
6
7
Table 19 – DIP Switch Group
NOTICE
Figure 28 – Dip Switch Detail
DO NOT MOVE
Vent Size
Gas Type
High Fire
Low Fire
OFF
DO NOT MOVE
2"
LP
Normal Operation
Normal Operation
40
ON
3"
NG
High Fire
Low Fire
WHL-015 REV. 5.20.16