Graco TrueCoat Plus II 24N812 Quick Setup Manual

Backpack sprayer

Download this manual

Operation

Quick Set-up Guide for TrueCoat Plus II

BackPack Sprayer

- For use with Graco hand-held sprayers (except Fine-Finish sprayers) -

- For portable spray applications of water-based and oil-based (mineral spirit-type)

IMPORTANT SAFETY INSTRUCTIONS

For complete warnings and safety

instructions, see sprayer manual.

Model 24N812

Maximum Working Pressure 12 psi (0.83 bar, 0.083 MPa)

FIRE AND EXPLOSION HAZARD

Use only water-based or oil-based (mineral spirit-type) materials with flash point greater than 100° F

(38° C). Do not use materials which state "FLAMMABLE" on the packaging. For more information about

your material, request MSDS from distributor or retailer.

Use oil-based material outdoors or in a well-ventilated indoor area with a flow of fresh air.

architectural paints and coatings only -

- Not approved for use in explosive atmosphere locations -

WARNING

3A2852B

ti16502b

Page 1 Quick Set-up Guide for TrueCoat Plus II BackPack Sprayer 3A2852B - For use with Graco hand-held sprayers (except Fine-Finish sprayers) - - For portable spray applications of water-based and oil-based (mineral spirit-type) architectural paints and coatings only - - Not approved for use in explosive atmosphere locations -...
Page 2 Before You Start Before You Start The ProPack Portable Spray Pack is shipped with a bat- 6. Connect battery and place inside air compressor. tery inside the air compressor which must be connected before operation. 1. Remove contents from backpack including any packing materials.
Page 3 Before You Start Setup Instructions 1. Perform Pressure Relief Procedure (see sprayer 7. Thread suction hose nut (S) onto lid assembly and manual). hand tighten. Insert drain hose (H) onto lid assem- bly barb and secure with clamp. 2. Remove sprayer battery or unplug sprayer. 3.
Page 4 Original instructions. This manual contains English. MM 3A2852 Graco Headquarters: Minneapolis International Offices: Belgium, China, Japan, Korea GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA Copyright 2012, Graco Inc. All Graco manufacturing locations are registered to ISO 9001. www.graco.com...